Applies to Moon wall-mount suction vanity mirror (model ID: EHBM01).
Please check the issues and solutions below.
Issue 1: You might forget removing the protective film of the suction.
Solution: Remove the protective film at the bottom of the suction before you use the suction makeup mirror.
Issue 2: The suction of the makeup mirror is smudged.
Solution: Clean the suction of the mirror with clean water and air-dry, and then it would be sticky to any flat surface again.
Issue 3: There is gap between the suction and adsorption site, or the adsorption site lies on the gap between two tiles.
Solution: Please make sure the suction is attached to a clean and smooth mirror or wall flat and voidless.
Issue 4: The suction is not locked tightly enough.
Solution: After the suction is attached to the surface firmly, turn the rotary switch to the lock position.
Comments
0 comments
Article is closed for comments.